Correct process and techniques for removing various filter elements of excavators

Also make sure the excavator is stopped and the engine is cool. In addition, since a small amount of oil will flow out when removing the oil filter, you need to prepare an oil container and protective gloves to prevent the oil from contaminating the ground and contacting the skin.

Apr 9th,2025 24 Views

Disassembly process

Find the location of the oil filter: The oil filter is generally located on the side or bottom of the engine. The location may be slightly different for different brands and models of excavators. Taking [another brand model] excavator as an example, its oil filter is on the side of the engine and is wrapped in a round shell. This involves "How to find the location of the excavator oil filter.

Release oil pressure: Before removing the filter, you need to release the oil pressure in the engine. This can usually be achieved by opening the oil drain bolt on the engine and releasing a small amount of oil. Note that you should drain the oil slowly to avoid oil splashing. This step corresponds to "How to release oil pressure before removing the excavator oil filter."

Remove the filter: Use a special oil filter wrench to clamp the filter housing, rotate it counterclockwise, and unscrew the filter. Some filters may be difficult to remove due to over-tightening or long-term non-replacement. At this time, you can gently tap the filter wrench to increase the torque to help unscrew the filter. This operation is similar to "Tips for using excavator oil filter removal tools" Related.

Tips

When using the oil filter wrench, make sure the wrench fits tightly against the filter housing to prevent slippage and damage to the filter or cause operational hazards.

If the filter is difficult to remove, try applying a small amount of oil to the filter housing to lubricate and facilitate unscrewing the filter.

Fuel filter removal

Preliminary preparation

In addition to stopping and cooling the engine, because fuel is flammable and explosive, before removing the fuel filter, be sure to disconnect the negative pole of the excavator's battery to prevent sparks from causing danger. At the same time, prepare a fire extinguisher just in case.
Disassembly process

Find the location of the fuel filter: The fuel filter is generally installed in the fuel line, close to the fuel tank or engine. The location of the fuel filter of different excavators is different. For example, the fuel filter of [a well-known brand] excavator is near the fuel tank and has an obvious filter seat. This is related to "How to determine the location of the excavator fuel filter" .

Release fuel pressure: Similar to the oil filter, you need to release the pressure in the fuel system first. This can be done by opening the bleed bolt on the fuel filter, or using a dedicated fuel pressure release tool. During operation, pay attention to the surrounding environment to avoid fuel leakage onto open flames or high-temperature objects. This step corresponds to "Tips for releasing fuel pressure before removing the excavator fuel filter."

Remove the filter: Use a wrench to unscrew the nut that fixes the fuel filter or loosen the buckle to remove the filter from the filter seat. When removing the filter, a small amount of fuel may flow out, which must be caught in an oil container. This step involves "Excavator fuel filter removal operation process".

Key points

When releasing fuel pressure, do it in a well-ventilated place to avoid fuel vapor accumulation.

During the removal of the fuel filter, if the nut or buckle is rusted and difficult to twist, you can use rust remover to spray on the rusted part and wait for a while before operating.

Correctly removing various types of filter elements of the excavator is an important part of ensuring its normal operation and maintenance. By following the above detailed process and skills, combined with the corresponding points of different types of filter elements, operators can complete the filter element removal work more safely and efficiently, providing strong guarantee for the stable operation of the excavator.

Choose DIG-DOG for high-quality, customizable brush cutters for skid steers with fast delivery. Contact us today to discover how our superior products can enhance your land management tasks!

Common Faults of Wheel Loader Gearbox

Innovation of loaders in complex mining environments

Company News

Industry dynamics

Correct process and techniques for removing various filter elements of excavators

CONTACT US